Step 2 Connect your PC or the other network devices to one of the four switched inside ports (numbered 1 through 4).Ĭonnecting a Power Supply Module to the PIX 501 Use the orange Ethernet cable (72-3515-01) to connect the device to a DSL modem, cable modem, or router.Use the yellow Ethernet cable (72-1482-01) to connect the device to a switch or hub.Step 1 Connect Port 0, the outside Ethernet port, to the public network. To install the PIX 501, perform the following steps: Place the PIX 501 on a flat, stable surface. The interface is enabled at 100 Mbps (autonegotiated). Also, the LED does not light up when PPTP/L2TP tunnels are established. If the standard configuration is not modified to support VPN tunnels, the LED does not light up because it is disabled by default. One or more IKE/IPSec VPN tunnels are disabled. One or more IKE/IPSec VPN tunnels are established. Try replacing the yellow, straight-through Ethernet cable with the orange, crossover Ethernet cable. Tip If the LINK/ACT LED does not light up, you might be using the wrong type of cable.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |